While normal, worn 1965 copper-nickel clad dimes (the kind you’re most likely to find in pocket change) are worth face value, some 1965 dimes have higher values: Uncirculated 1965 dimes (the kind that have never been spent as money) are worth about 30 cents and up.
Who designed the Roosevelt dime?
John R. Sinnock
Roosevelt dime
| Mint marks | P, D, S, W. Located from 1946 to 1964 on the lower reverse to the left of the torch, since 1968 on the obverse above the date. No mint mark used at Philadelphia before 1980 or at any mint from 1965 to 1967. |
| Obverse | |
|---|---|
| Design | Franklin D. Roosevelt |
| Designer | John R. Sinnock |
| Design date | 1946 |
Where is the mint mark on a 1965 dime?
Mint Marks. Roosevelt Clad Dimes were produced at four different mints: Philadelphia (1965-1979: no mint mark. 1980-date: P), Denver (D), San Francisco (S) and West Point (W). As illustrated in the picture link below, the mint mark is located on the obverse of the coin, near the lower right side above the date.
Why was there a shortage of silver dimes in 1965?
In 1965, the United States began converting all of its silver coins to a copper-nickel clad composition. John Sinnock’s design of the Roosevelt dime remained unchanged. However, the United States Mint continued to blame the coin shortage on coin collectors.
Who was the first person to design a dime?
The design of the very first Roosevelt Dime was by a United States Mint employee, Chief Engraver John R. Sinnock. It was the first coin designed by a Mint employee in over four decades, due to the lack of time to commission the design to another designer.
When did they stop putting mint marks on dimes?
Therefore from 1965 through 1967, they removed all mint marks from United States coins. Beginning in 1968, the mint resumed using mint marks to identify where the coins were made. Roosevelt dimes are still made for circulation by the United States Mint.
