If you need to replace your car’s shock absorbers but don’t want to pay an expensive mechanic’s fee, you can do so on your own with a little effort. Shocks are essential to a car’s performance, giving it a smooth and even ride. Over time, however, the vehicle’s suspensions become worn out.
What are the signs of bad rear shocks?
The Warning Signs Of Worn Shocks And Struts
- Instability at highway speeds.
- Vehicle “tips” to one side in turns.
- The front end dives more than expected during hard braking.
- Rear-end squat during acceleration.
- Tires bouncing excessively.
- Unusual tire wear.
- Leaking fluid on the exterior of shocks or struts.
How long does it take to replace a rear shock?
It takes about 2-3 hours to replace a single set of shocks, as does either side’s control arms. However, it may take less time for lesser work such as replacing a spring.
How much does it cost to replace rear shocks?
On average, replacing rear shocks is going to run you somewhere between $1,000 and $1,130. And there is very little wiggle room for those looking for a deal. The parts associated with rear shock replacement come in at right around $900 and make up the bulk of the rear shock replacement cost.
Will new shocks make ride smoother?
Shocks and struts help keep the vehicle stable during acceleration and braking. The customer may think that new shocks and struts will simply make their ride smoother, but the truth is that new shocks and struts can do a whole lot more. New shocks and struts can make a vehicle corner and brake like when it was new.
How hard is it to change shocks?
Shocks are relatively simple and cheap. Struts are more complicated and you will need a spring compressor to remove the springs. After replacing the front struts you will need to get a wheel alignment.
Can you replace rear shocks without a jack?
You do not need to jack up the truck to remove or replace the REAR shocks. If you need to replace your car’s shock absorbers but don’t want to pay an expensive mechanic’s fee, you can do so on your own with a little effort. Shocks are essential to a car’s performance, giving it a smooth and even ride.
Do you need alignment after replacing rear shocks?
In general, you don’t need an alignment done after replacing shocks on a vehicle with the older style front suspension typically found on rear wheel drive vehicles. Replacing those shocks has nothing to do with the alignment whatsoever unless the spring has lost some of it’s tension.
How to change rear suspension on Ford Mondeo?
To change jack up rear and support body on stands, removing the rear wheels helps. Sub-frame is held in with 4 X 15mm bolts. These will be tight as they are torqued to 120nM. Basically do one bush at a time by removing one bolt completely and loosening off the other 3 bolts.
How do you replace rear shocks on Mercedes Benz?
Use your plastic trim removal tool, or a handy flat-head screwdriver to remove the clips. Figure 2. Remove the top two carpet fasteners by pinching the fastener together, which will release the pin from its mounting hole. Remove the two 17mm nuts at the top of the shock inside the trunk. Use your 17mm open end wrench to hold the lower nut.
How do you remove a shock from a suspension?
Use a socket set or a nut splitter to disengage the nut that connects the shock to the suspension, and remove it from the bolt. If there isn’t enough room to operate the splitter, you can apply penetrating solvent.
How do you replace a Ford rear shock absorber?
On some Ford products there’s an external motor drive, and you can unplug it from the old shock and install it on the new one. In most other cases, you get a choice of shock absorber designs. If the shock rod spins endlessly as you try to remove the upper mount, try Vise-Grips on the flatted end of the rod.
